|
|
![Multiplex Easy Glider Pro Kit 72" Б\У [M214226_USED]](Images\Upload/M214226_USED.jpg)
|
Multiplex Easy Glider Pro Kit 72" Б\У [M214226_USED]
Модель планера Multiplex Easy Glider Pro Kit 72" - KIT комплект (без электроники, Б/У)
В хорошем...
|
 |
| в наличии: |
 0 /комплект/ |
|
|
|
Модель планера Multiplex Easy Glider Pro Kit 72" - KIT комплект (без электроники, Б/У)
В хорошем состоянии, вклеены 2 сервы 9г HXT900 на элеронах
Может быть исполнена как в моторном так и в безмоторном варианте
FEATURES: Construction: Elapor foam to resist damage, white in color
Wings: Two piece with fiberglass wing joiner
Spinner: Elapor foam 2.2″ (55mm) diameter
Aileron Control: Dual servo
Control Surfaces: Elevator, rudder and ailerons
INCLUDES: One Multiplex Easy Glider Pro with decal sheet, foam spinner, wing
joiner, pushrods, hardware and illustrated instruction manual
REQUIRES: Radio System: 4-channel with micro receiver
Servos: Two micro size for elevator & rudder
Two nano size for ailerons
Servo Extensions: Two 16″ (200mm) for aileron servos
Y Harness: For aileron servos
Battery: at least 2100mAh
Battery Charger: LiPo compatible
If building as glider only the following items are required;
NiMH Receiver Battery (at least 1800mAh)
Switch Harness with Charge Jack
Launching Kit
If installing electric power, the Brushless Motor Power Pack
(MPUG3226) is required
Building and Field Equipment: Medium viscosity regular (NOT styrofoam
safe) CA glue and activator, see COMMENTS
SPECS: Wingspan: 72″ (1828mm)
Length: 44″ (1117.6mm)
Flying Weight: 28.5oz (810g) with standard power system
Wing Loading: 6.5 oz sq ft (20 g sq/dm) with standard power system
Wing Area: FAI approx. 645 sq in (41.67 sq dm)
Airfoil: Semi symmetrical
CG (Center of Gravity): 2.7″ (70mm) from leading edge at wing root
measured at fuselage side
Control Throws-
Elevator, Up and Down: 0.31-0.39″ (8-10mm)
Rudder, Left and Right: 0.59-0.79″ (15-20mm)
Ailerons, Up: 0.59″ (15mm)
Down: 0.24″ (6mm)
Spoilers-Both Ailerons Up: 0.79″ (20mm)
Spoiler Mixer (Elevator Trim Compensation): 0.16″ (4mm)
COMMENTS: This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium CA glue used with an
activator is the only method of gluing recommended by the
manufacturer.
|
|
|
|
|
|